Mosfet Output Module

John Phillips

This is a board that allows the Kookaberry to operate peripherals that require current greater than 100 milliamps. For example, the mini-pump used with the WaterMe App has to use this board. Power to the Kookaberry The Kookaberry has a generous and protected power supply which allows voltages to be used from different sources. Internally it takes an incoming voltage …

Particle Sensor Interface Module

John Phillips

This is a board that allows the Kookaberry to operate with the SDS011 particle sensor.   Typical Setup

Pin swap module for IR Temperature sensor

John Phillips

This is a small, in-line, module needed to swap one of the wires in a 4-wire connecting cable to allow the non-contact IR Temperature sensor to work with the Kookaberry           What it does The arrangement of the VCC, GND, and the two signal connections on DFRobot non-contact IR Temperature sensor module does match the connection …